WKv Series Low Energy Heat of Compression Compressed Air Dryers (Full Stream)
Images are representations only.

WKv Series Low Energy Heat of Compression Compressed Air Dryers (Full Stream)

Brand: Zander
Request Information

Parker Zander WKv series compressed air dryers are fully automatic dryers which utilize full flow regeneration principles to dry compressed air down to a pressure dew point of -20 °C.

WKv series dryers are so called heat of compression dryers (HOC), in contrast to conventional adsorption dryers, HOC dryers make use of excess heat from oil-free compressors to regenerate the desiccant beds thereby eliminating the requirement for an installed heater. 

HOC dryers are therefore a cost and energy efficient solution.

WKv series come with a ZDMC controller as standard that offers full process visualization and advanced connectivity.

WKv series compressed air dryers are available for volume flows up to 14500 m³/h with a standard maximum operating pressure up to 10 barg. 

Higher flow rates, operating pressures or temperature ratings are available on request.
Features
  • Volume flows up to 14500 m³/h @ 7 bar g
  • Maximum operating pressure 10 bar g - higher pressures on request
  • Pressure dew point: -10 to -50°C - lower dew points available on request
  • Operation with up to 3 compressors
  • Operation with low flows (30%)
  • Very low operating costs by using the compressor heat - only cost is power for the control unit
  • Very quiet operation - no purge / expansion, no blower or vacuum pump
  • Low service costs - no heater, no blower, no load changes
Many additional options are available to suit specific customer requirements.

Specifications

Brand

Maximum Flow Rate (at 101 psig / PDP - 4° F)

  • 247 to 8534 CFM

Maximum Operating Temperature

  • 104° F
  • 40° C

IP Protection Rating

  • IP54

Minimum Ambient Temperature

  • 1.5° C (Insulation Required if Temperature is Below 15° C)

Electrical Requirements

  • 230 V, 50/60 Hz

Power Consumption

  • depends on Design

Maximum Ambient Temperature

  • 50° C

Minimum Operating Pressure

  • 2.5 barg

Maximum Operating Pressure

  • 145 psig
  • 10 barg

Minimum Operating Temperature

  • 68° F
  • 20° C

Width

  • 1250 to 3750 mm

Connection Type

  • Flange According to EN 1092-1

Controller Type

  • ZDMC2

Depth

  • 950 to 2500 mm

Height

  • 2355 to 4440 mm

Approvals & Certifications

  • Others on Request
  • PED

Water Consumption

  • 3.50 m³/hour to 121.30 m³/hour

Dryer Technology

  • Fully Automatic Adsorption Dryer with Heat of Compressor Usage for Full Flow Regeneration

Pressure Dew Point

  • 14 to -58° F
  • -10 to -50° C

Port Size

  • DN 40 to DN 200

Weight

  • 616 to 16350 kg
show more